KYOCERA KM-1810 DRIVER

Remove the paper feed shaft unit from the lower front side of the machine. Remove the printer cover and right cover and then the contact glass. ST paper feed pulleys Remove the two pins securing the option plate on the printer board and then remove the plate. Description Setting range Initial setting Also to clear the counts after replacing the consumable parts.

Uploader: Daigal
Date Added: 10 October 2016
File Size: 18.62 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 45756
Price: Free* [*Free Regsitration Required]

Replace the laser scanner unit and refit all the removed parts. Open the front cover and remove the waste toner tank and toner container. A selection item appears. Turns the AC power on and off.

Check the number of copies kypcera with the current developer. Main charger unit Tungsten wire Drum A paper jam in the clutch malfunctions. The current setting is displayed. Page 19 – Drive system 3 original feed motor Remove the stop ring, and then remove the Stop ring DF feed pulley.

U Setting high voltages Description Changes the developing bias voltage and transfer voltage by changing the developing bias control voltage and transfer control voltage. Insert the power plug and turn the main switch on. If a paper jam occurs frequently in the eject section when the number of copies is counted at the time of paper ejection, copies are provided without copy counts.

  CQ40-115AU VISTA DRIVER DOWNLOAD

Remove the screw holding the original feed guide and then the guide. Power Adapter Power Consumption Operational.

Kyocera Mita KM-1810 Service Manual

The scanner and mirror frames travel to scan on the optical rails on the front and rear of the machine to scan from side to side. The height of the magnetic brush is regulated by the doctor blade; Install a toner container.

Press the start key. If necessary, protect it with a cable cover or other appropriate item.

Fixing section release levers Figure Remove the tapes, pads and sheet inside the drawer. U Checking motor operation Description Drives each motor. Page – Adjusting the leading edge registration Remove the two pins securing the option plate on the printer board and then remove the plate.

KYOCERA MITA KM SERVICE MANUAL Pdf Download.

Manually turn on and off each switch to check the status. Remove the ST paper feed unit see page 1- Remove the printer cover from the copier by firmly pressing the part marked with a triangle. Remove the four screws and then detach the high-voltage transfer PCB. Procedure Scanner leading edge margin 3 2.

  AW-GE780 NE770 WIRELESS LAN DRIVER

Purpose Used if the exposure amount differs significantly between when scanning an original on the contact glass and when scanning an original from the DF.

The developing unit consists of the developing roller where a magnetic brush is formed, the doctor blade and the developing spirals that agitate the developer. Primary paper feed from the drawer.

Paper feed pulleys 7. Discussion threads can be closed at any time at our discretion. Remove the tapes, pads and sheet inside the drawer.